JobOx update parts
In this section you will find parts which will update your JobOx to the latest revision. These parts are not intended to add or extend functionality but to increase the reliability of your JobOx.
#cross-connection-reinforcer
Cross connection reinforcer for the Magazine unit
This modification solves the problem of corner connectors that lose alignment after a while.
This new part should be mounted underneath cross connection of the Magazine unit in order to make it stiffer and more reliable. To apply this update, the Magazine unit needs to be partly disassembled. All screws and connectors will be reused.
This reinforcement part can be applied to all Magazine units, which were delivered without such part (all Magazine revisions before M003). Version label can be found on one of the extrusion profiles (inside the slot).
3D file can be downloaded on Printables.com (link below).
Download M08_cross-connection-reinforcer
#plate-support
Plate backflip protection for Ejection unit
This little part will extend the Ejection unit towards the printer, preventing the unloaded spring sheet from flipping back and become jammed by the mowing heat bad. Original screws can be reused.
This update is for Ejection unit revision E001 only. Later version don't need this update. Version label can be found on one of the extrusion profiles (inside the slot).
3D file can be downloaded on Printables.com (link below).