JobOx v1.5 - 3D printing automation system for Prusa MK3s/MK4*

Discount (applied automatically on checkout):

• 1-3 Units:  regular price
• 4-7 Units:  6% off
• 8+ Units:   10% off

JobOx is a smart upgrade for your Prusa MK3S+ and MK4 printer¹ that allows you to automate your 3D-printing process quickly and easily.

The JobOx hardware comes to you pre-assembled and can be set up in around 5 minutes.  To learn more about the setup process needed to run JobOx system, please read here.

JobOx consists of a magazine and unloading (ejecting) unit. Magazine can contain up to 8 JobOx build plates² or 6 Original Prusa build plates³.

What's new in JobOx version 1.5?

In this version we improved the compatibility with MK4. We added a feature which should stops the printer if the magazine goes empty and no build plate was loaded. Also we added some modifications which improves the overall reliability of the system. 

IMPORTANT INFORMATION: Todays firmware of MK4 do NOT offer a collision detection. We hope it will be implemented on MK4 one day. But for now we just want point out our WARNING, that using JobOx system on MK4, can possibly cause damage of the printer and therefore still EXPERIMENTAL ONLY.

*MK4 compatibility: 

When JobOx is shipped it is ready to be used on MK3 series but can be adapted to Prusa MK4. In this case an adapter kit needs to be printed and attached to JobOx magazine and ejecting unit.  There are also some technical details that you should take into account before using the JobOx on a Prusa MK4. Please read this information (link).

This kit is not yet tested on MK3.5/MK3.9. 

Please Note:

1. A printer is not included. It can be ordered from Prusa Research. See also disclaimer below.
2. Jobox build plates are not included and should be ordered separately.
3. When using Original Prusa build plates within the Jobox system - additional retrofit adapters are needed. These can be ordered separately.